38 Maintaining and Troubleshooting the Gateway ALR 7200 Server
12.
The system should automatically recognize the new drive. If it does
not, you may need to set jumpers on the drive or change settings in the
BIOS Setup utility.
Adding an Expansion Card
The system board has seven (7) expansion slot connectors. The system
board accepts two types of expansion cards: ISA and PCI. Some of the PCI
expansion slots are designed to allow the slot to be shared with a special
purpose expansion card such as a RAIDport card.
Some ISA expansion cards have jumpers or switches that set interrupts and
I/O addresses. They come with instructions that explain how to set them to
avoid hardware conflicts. Follow the instructions carefully.
Refer to Figure 4 on page 10 for the correct installation location.
1.
Set any jumpers and switches on the card, if required in the card
instructions.
2.
Turn off the system and disconnect the power cord.
3.
Open the case, observing the static electricity precautions in
Chapter 1.
4.
Locate an open slot of the correct type.
5.
Remove and retain the screw securing the expansion port cover to the
rear cover. Keep the port cover for reinstallation in case you ever need
to remove the card.
To add an expansion card
3436.book Page 38 Friday, August 7, 1998 10:23 AM
