Troubleshooting 97
Non-system disk or disk
error.
Eject the diskette and press
E
NTER
.
If the diskette is bootable, check it for errors.
Not enough memory.
Close all programs that are not currently in
use.
Print queue is full.
Wait until the current print job has completed
before sending another print job.
If you receive this error often, you need to
add memory to the printer.
Printer is out of paper.
Add paper to the printer.
Make certain the printer is online.
Required parameter
missing.
Make certain you entered the right
command.
If you are trying to exit MS-DOS to return to
Windows, type exit and press
E
NTER
.
Syntax error.
Make certain you entered the right
command.
If you are trying to exit MS-DOS to return to
Windows, type exit and press
E
NTER
.
Time and date not set.
Enter BIOS Setup to set the system’s date
and time.
Update table not found
for CPUxx, Stepping xxxx
Run the MULOADER utility. A new
processor that was added may not include
the stepping information in the table or the
BIOS may have been flashed and the
stepping information removed from the
table.
Write protect error.
Move the write-protection tab over the hole
on the back of the diskette.
Error Message
Solutions
4079tl.book Page 97 Tuesday, December 22, 1998 2:04 PM
