Components 17
CPU setting jumper
This jumper allows you to set the speed of the processor. Both processors,
in dual processor configurations, must have the same speed rating. If
processors of different speeds are used in the same system, the processors
must run at the speed of the slower processor.
Battery
Provides the power to maintain the CMOS memory when the system is
turned off or unplugged.
Expansion slots
The system features eight expansion slots: five PCI slots, one ISA slot, one
PCI/RAIDport, and one shared PCI/ISA slot.
The PCI bus processes peripheral transactions at a system clock speed of up
to 33 MHz.
I/O connectors
The I/O connectors are located on the back panel of the system. Figure 8
shows the connectors and the table below provides a key to the figure.
Caution!
There is a danger of
explosion if the battery is
incorrectly replaced.
Replace the battery only
with the same or equivalent
type recommended by the
manufacturer. Dispose of
used batteries according to
the manufacturer’s
instructions.
4079tl.book Page 17 Tuesday, December 22, 1998 2:04 PM