Installing Components 37
11.
Close the case (see page 6 for instructions).
12.
Reconnect the power cord and turn on the system.
Replacing the CD-ROM drive
The 5.25-inch drive bay can be used to install a CD-ROM drive, diskette
drive, or other 5.25-inch device.
1.
Turn off the system and disconnect the power cord.
2.
Open the case (see page 3 for instructions), observing the static
electricity precautions on page 2.
3.
Locate the CD-ROM drive.
4.
Disconnect the power and data cables from the back of the drive,
noting their location and orientation. (You will reconnect these cables
after you install the new CD-ROM drive.)
5.
Remove the screws securing the drive bracket to the chassis, then
remove the drive from the chassis.
6.
Remove the screws securing the CD-ROM drive to the mounting
bracket and then remove the CD-ROM drive.
7.
Place the new CD-ROM drive in the mounting bracket.
8.
Secure the drive to the mounting bracket using the screws you
removed in Step 6.
9.
Place the drive into the chassis.
To replace the CD-ROM drive
4079tl.book Page 37 Tuesday, December 22, 1998 2:04 PM
