Installing Components 41
Replacing a 3.5-inch drive in the top drive
bay
Above the 3.5-inch diskette drive, there is a single bay for an internal
3.5-inch hard drive. This drive can be either IDE or SCSI.
1.
Turn off the system and disconnect the power cord.
2.
Open the case (see page 3 for instructions), observing the static
electricity precautions on page 2.
3.
Disconnect the data and power cables from the drive in the top drive
bay.
4.
Remove the two screws that secure the right side of the drive to the
chassis and the two screws that secure the bracket to the left side of the
5.25-inch drive cage (see Figure 19).
Figure 19: Removing the 3.5-Inch Drive from the Top Drive Bay
To replace the 3.5-inch drive in the top drive bay
4079tl.book Page 41 Tuesday, December 22, 1998 2:04 PM