Troubleshooting 83
Memory/processor problems
Memory errors were detected during system start up.
A new processor is not recognized by the system.
Probable Cause
Solution
Memory was added or
removed, and the new
configuration was not
saved in BIOS Setup.
Enter BIOS Setup and save the new memory
configuration.
The memory was
installed incorrectly.
Check the memory for proper seating and
orientation.
A memory chip is
faulty.
Replace the card with the faulty chip.
(Third-party diagnostic programs can help
determine which chip or memory segment is
failing.)
Probable Cause
Solution
The processor was
installed incorrectly or
in the wrong socket.
Check the installation. The processor should
be recognized automatically if it was installed
correctly.
The processor speed
was not selected on
the system board.
If your system board lets you to select the
processor speed, make sure you have selected
the proper speed.
A pin was bent on the
processor during
installation.
Remove the processor and inspect it for
damage. If a pin is bent, very carefully try to
straighten it.
Stepping information is
not included in the
table when a new
processor is installed.
Run the MULOADER utility.
4079tl.book Page 83 Tuesday, December 22, 1998 2:04 PM
