4 Gateway ALR 8200 User’s Guide
Setting up the server
Refer to Figure 1 and the following procedures when connecting optional
peripherals to your system.
Figure 1: Connecting Peripherals
1.
Connect the keyboard and mouse to their respective ports using the
pictures on the server’s rear cover as a guide.
2.
Connect the monitor video cable to the video port. The location of the
port may vary depending on whether you use the integrated video or a
video card.
3.
Connect the monitor power cable to an AC outlet or, preferably, a
surge control outlet station.
4.
Verify that the voltage selector switch on the power supply is set for
the proper voltage (115V or 230V). If the system includes two
hot-swap modules, each module has a voltage selector switch.
Important!
Shielded cables are
required by the FCC.
4078tl.book Page 4 Tuesday, December 22, 1998 2:19 PM
Summary of Contents for ALR 8200
Page 10: ...viii Gateway ALR 8200 User s Guide 4078tl book Page viii Tuesday December 22 1998 2 19 PM...
Page 18: ...8 Gateway ALR 8200 User s Guide 4078tl book Page 8 Tuesday December 22 1998 2 19 PM...
Page 36: ...26 Gateway ALR 8200 User s Guide 4078tl book Page 26 Tuesday December 22 1998 2 19 PM...
Page 48: ...38 Gateway ALR 8200 User s Guide 4078tl book Page 38 Tuesday December 22 1998 2 19 PM...