8 Maintaining and Troubleshooting the Gateway ALR 9000 Server
Installing a CPU
1. Open the system as described on page 15.
2. Remove the screws that secure the CPU card to the chassis as shown below.
Save the screws.
3. Locate the ejector arms on each outer corner of the CPU card and pull them
outward (away from each other) to release the card from its slot (see Figure
5).
4. Holding on to the ejector arms, gently pull out the CPU card (A or B
depending on how many CPUs are already installed in your system).
5. Lay the CPU card (socket side up) on a flat, static-free surface.
Figure 4: Removing the CPU Card
Figure 5: CPU Card Ejector Arms (Out)
Note:
If you are unsure of the
location of the CPU
cardslots, refer to the
System User’s Guide
for
the illustration of the system
board.
Maints.boo Page 8 Friday, July 10, 1998 1:47 PM
