CHAPTER 4: Troubleshooting
52
The
Create Backup Disc
dialog box opens.
This dialog box tells you the number of blank,
recordable discs you will need to complete the
recovery discs. Make sure that you have the
required number of identical, blank discs ready
before continuing.
3 Insert a blank disc into the drive indicated in the
Burn to list, then click Next. The first disc begins
recording, and you can watch its progress on the
screen.
When the disc finishes recording, the drive ejects
it.
4 Remove the disc from the drive and mark it with
a permanent marker.
5 If multiple discs are required, insert a new disc
when prompted, then click OK. Continue
recording discs until the process is complete.
Recovering pre-installed software and
drivers
As a troubleshooting step, you may need to reinstall
the software and device drivers that came pre-installed
on your computer from the factory. You can recover
using either your hard drive or the backup discs you
have created.
•
New software—If you need to recover software
that did
not
come pre-installed on your
computer, you need to follow that software’s
installation instructions.
•
New device drivers—If you need to recover
device drivers that did
not
come pre-installed on
your computer, follow the instructions for
updating drivers in
“Checking for device
problems” on page 50
.
Important
Write a unique, descriptive label on each disc, such as
“Windows Recovery Disc 1 of 2.” or “Apps/Drivers Recovery
disc.”
Summary of Contents for DX4300
