95
www.gateway.com
3
Click
Add
. The network properties dialog box opens.
4
Type the name of the network in the
Network name (SSID)
box.
5
Click the arrow button to open the
Network Authentication
list, then click the network
authentication option you want.
6
If this is a security-enabled network, click the arrow button to open the
Data encryption
list, then click
WEP
.
7
If the WEP network key
is not
provided automatically, click to clear
The key is provided
for me automatically
check box, then type the network key settings in the
Network key
and
Confirm network key
boxes to match those set on the access point.
- OR -
If the WEP network key
is
provided automatically, then leave the check mark selected
in
The key is provided for me automatically
check box.
8
Make sure that the
This is a computer-to-computer (ad hoc) network; wireless access points
are not used
check box is not selected.
9
Click
OK
to close the Wireless Network Properties dialog box. Your network should be
running. Go to
Summary of Contents for E-2300
