19
www.gateway.com
To set the voltage selection switch:
■
Use a tool such as an opened paper clip to slide the voltage selection switch to the
correct voltage position.
Starting your computer
To start your computer:
1
Connect the cables to your computer. See the setup poster for setup instructions.
2
Turn on your computer.
3
If you are starting your computer for the first time, follow the on-screen instructions
to set up your computer.
4
Turn on any peripheral devices, such as printers or scanners, and see the
documentation that came with the device for setup instructions.
Important
Your computer has a built-in variable speed fan. In addition, your
computer uses a powerful processor which produces heat. Both the
system fan and processor can run at different speeds at times to
ensure proper system cooling. You may notice an increase in the fan
noise when the fan is running at high speed and a decrease in the
fan noise when it switches to normal speed.
Voltage switch
Summary of Contents for E-2300
