Gateway E-2300 User Manual Download

Page: 120 / 134

114

www.gateway.com

Important safety information

Your Gateway system is designed and tested to meet the latest standards for safety of information technology
equipment. However, to ensure safe use of this product, it is important that the safety instructions marked on the
product and in the documentation are followed.

Setting up your system

■

Read and follow all instructions marked on the product and in the documentation before you operate your
system. Retain all safety and operating instructions for future use.

■

Do not use this product near water or a heat source such as a radiator.

■

Set up the system on a stable work surface.

■

The product should be operated only from the type of power source indicated on the rating label.

■

If your computer has a voltage selector switch, make sure that the switch is in the proper position for your area.
The voltage selector switch is set at the factory to the correct voltage.

■

Openings in the computer case are provided for ventilation. Do not block or cover these openings. Make sure
you provide adequate space, at least 6 inches (15 cm), around the system for ventilation when you set up your
work area. Never insert objects of any kind into the computer ventilation openings.

■

Some products are equipped with a three-wire power cord to make sure that the product is properly grounded
when in use. The plug on this cord will fit only into a grounding-type outlet. This is a safety feature. If you are
unable to insert the plug into an outlet, contact an electrician to install the appropriate outlet.

■

If you use an extension cord with this system, make sure that the total ampere rating on the products plugged
into the extension cord does not exceed the extension cord ampere rating.

■

If your system is fitted with a TV Tuner, cable, or satellite receiver card, make sure that the antenna or cable
system is electrically grounded to provide some protection against voltage surges and buildup of static charges.

Care during use

■

Do not walk on the power cord or allow anything to rest on it.

■

Do not spill anything on the system. The best way to avoid spills is to avoid eating and drinking near your
system.

■

Some products have a replaceable CMOS battery on the system board. There is a danger of explosion if the
CMOS battery is replaced incorrectly. Replace the battery with the same or equivalent type recommended by
the manufacturer. Dispose of batteries according to the manufacturer’s instructions.

■

When the computer is turned off, a small amount of electrical current still flows through the computer. To
avoid electrical shock, always unplug all power cables and modem cables from the wall outlets before cleaning
the system.

■

Unplug the system from the wall outlet and refer servicing to qualified personnel if:

■

The power cord or plug is damaged.

■

Liquid has been spilled into the system.

■

The system does not operate properly when the operating instructions are followed.

■

The system was dropped or the cabinet is damaged.

■

The system performance changes.