26
www.gateway.com
Connecting the modem
Your computer may have an optional 56K modem that you can use to connect to a standard
telephone line.
To connect the modem:
1
Insert one end of the modem cable into the modem jack
on the back of your
computer.
2
Insert the other end of the modem cable into a telephone wall jack. The modem will
not work with digital or PBX telephone lines.
3
Start your computer, then start your communications program.
Connecting to a wired Ethernet network
Your computer has a network jack that you can use to connect to a 10/100 wired Ethernet
network.
To connect to a wired Ethernet network:
1
Insert one end of the network cable into the network jack
on the back of your
computer.
2
Insert the other end of the network cable into a network jack.
Warning
To reduce the risk of fire, use only No. 26 AWG or larger
telecommunications line cord.
Important
Your computer is equipped with a built-in Ethernet port.
For information about setting up a wired or wireless Ethernet network,
see
Summary of Contents for E-2300
