Replacing the system board
79
10
Reconnect the expansion card cables (if
any) using your notes from Step 6, or, if
adding a new card, follow the
manufacturers instructions.
11
Return your computer to its upright
position.
12
Replace the side panel by following the
instructions in “Replacing the side panel”
on page 55.
Replacing the system board
To replace the system board:
Tips & Tricks
You need a Phillips
screwdriver to replace
the system board.
1
Remove the side panel by following the
instructions in “Removing the side panel”
on page 51.
2
For more stability, place your computer on
its side. To avoid scratching the case, place
it on a towel or other non-abrasive surface.
3
Disconnect any cables that are attached to
any expansion cards, noting their locations
and orientation. (You will reconnect the
cables after you install the cards on the
new board.)
8511781.book Page 79 Tuesday, October 10, 2006 4:41 PM
