122
www.gateway.com
Wireless Ethernet network
You turned the wireless on, but it takes a while to connect.
■
When the wireless emitter is turned on, it automatically scans for available
connections, which can take approximately 30 seconds to complete.
Your connection on the network seems intermittent.
■
In addition to other factors, the strength of a wireless connection is determined by
the distance from the access point and structural material that the signal must travel
through (such as walls, cabinets, ceilings, and floors.)
If you cannot relocate, see if you can improve the connection by changing the channel
of the access point.
Your wireless Ethernet network is running slower than you expect
■
If your wireless Ethernet network is running slower than you expect, you should check
your network signal strength. If you find the signal strength is low, try moving to a
new location to increase the signal strength.
To check the signal strength of your wireless Ethernet network:
1
Click
Start
, then click
Control Panel
. The Control Panel window opens. If your
Control Panel is in Category View, click
Network and Internet Connections
. The
Network and Internet Connections window opens.
2
Click/Double-click
Network Connections
. The Network Connections window opens.
Important
Signal strength is affected by the distance between your wireless
network devices, by radio interference, and by interference from
natural obstructions such as walls, floors, and doors.
Summary of Contents for Gateway Profile 5
