26
Chapter 2: Getting Started
www.gateway.com
Setting up your DVD/CD-RW drive
To set up your DVD/CD-RW drive:
1
Verify that the S/W switch (located on the back of the drive) is set to
OFF
.
2
Plug the power cord into the DC in connector on the back of the drive,
then plug it into an AC power outlet. Use only the AC power adapter that
came with your drive.
3
Plug one end of the IEEE 1394 or USB 1.1 cable into the 36-pin connector
on the back of the drive.
4
With the tablet turned on, plug the other end of the cable into the
corresponding port on the tablet or into the FlexDock. Windows XP
automatically recognizes the new drive and installs the correct driver.
5
Open the drive tray by pressing the eject button, then insert the Nero
Burning ROM CD into the drive and follow the on-screen instructions to
complete the installation.
6
Insert the CyberLink PowerDVD CD into the drive and follow the on-screen
instructions to complete the installation.
Headphone jack
DC power
36-pin
connector
S/W switch
Eject button
Status
Manual
eject hole