21
www.gateway.com
Connecting the AC adapter
Connecting the AC adapter
You can run your notebook using an AC adapter or your notebook’s
battery. The battery was shipped to you partially charged. You should use
the AC adapter right away to fully charge the battery. Allow three hours
for the battery to fully charge.
To connect the AC adapter:
1
Connect the power cord to the AC adapter.
Important
If the battery is not fully charged before you use your
notebook on battery power for the first time, the battery life
may be much shorter than you expect. If the battery life
seems short even after being charged for three hours, the
battery may need to be recalibrated. For information on
recalibrating the battery, see
“Recalibrating the battery” on
.
Caution
Make sure that you use the AC adapter that came with your
notebook or one of the same type purchased from
Gateway.
Replace the power cord if it becomes damaged. The
replacement cord must be of the same type and voltage
rating as the original cord or your notebook may be
damaged.
Summary of Contents for M210
