Gateway MX6633 Hardware Reference Manual Download

Page: 55 / 68

www.gateway.com

United States of America

Caution

Wireless devices are not user-serviceable.

Do not modify them in any way.

Modification to a wireless device will void

the authorization to use it. Contact

Gateway for service.

Caution

The transmitting device embedded in this

notebook may not be used with any

antenna other than the one provided

with the notebook.

Caution

In order to comply with FCC requirements
this transmitter must not be operated (or
co-located) in conjunction with any other

transmitter or antenna installed in the

notebook.

Federal Communications Commission (FCC) Intentional emitter per FCC Part 15

Low power, Radio transmitter type devices (radio frequency (RF) wireless
communication devices), operating in the 2.4 GHz band and/or 5.15 – 5.35 GHz
band, may be present (embedded) in your notebook system. This section is only
applicable if these devices are present. Refer to the system label to verify the
presence of wireless devices.

Wireless devices that may be in your system are only qualified for use in the
United States of America if an FCC ID number is on the system label.

The FCC has set a general guideline of 20 cm (8 inches) separation between the
device and the body, for use of a wireless device near the body (this does not
include extremities). This device should be used more than 20 cm (8 inches)
from the body when wireless devices are on. The power output of the wireless
device (or devices), which may be embedded in your notebook, is well below
the RF exposure limits as set by the FCC.

The wireless devices installed in this system are intended to be used indoors.
In some areas, use of these devices outdoors is prohibited.

Operation of this device is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation of the device.

Unintentional emitter per FCC Part 15

This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio and television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

■

Reorient or relocate the receiving antenna

■

Increase the separation between the equipment and receiver

■

Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected

■

Consult the dealer or an experienced radio/TV technician for help.

Compliance Accessories

: The accessories associated with this equipment are:

shielded video cable when an external monitor is connected. These accessories
are required to be used in order to ensure compliance with FCC rules.