Gateway NX860, Hardware Reference Manual

Regulatory compliance statements

www.gateway.com

51

The telephone company may make changes in its facilities, equipment, 
operations, or procedures that could affect the operation of this equipment. If 
this happens, the telephone company will provide advance notice in order for 
you to make necessary modifications to maintain uninterrupted service.

This equipment cannot be used on telephone company-provided coin service. 
Connection to party line service is subject to state tariffs. Contact the state 
public utility commission or public service commission for information.

When programming or making test calls to emergency numbers:

■

Remain on the line and briefly explain to the dispatcher the reason for the 
call.

■

Perform such activities in the off-peak hours such as early morning or late 
evenings.

The United States Telephone Consumer Protection Act of 1991 makes it 
unlawful for any person to use a computer or other electronic device to send 
any message via a telephone fax machine unless such message clearly contains, 
in a margin at the top or bottom of each transmitted page or on the first page 
of the transmission, the date and time it is sent, an identification of the business, 
other entity, or other individual sending the message, and the telephone 
number of the sending machine or such business, other entity, or individual. 
Refer to your fax communication software documentation for details on how 
to comply with the fax-branding requirement.

Canada

Industry Canada (IC) Intentional emitter per RSS 210

Caution

To prevent radio interference to licensed

service or co-channel Mobile Satellite

systems, this device is intended to be

operated indoors and away from

windows to provide maximum shielding.
Equipment (or its transmit antenna) that

is installed outdoors is subject to

licensing.

Caution

Wireless devices are not user-serviceable.

Do not modify them in any way.

Modification to a wireless device will void

the authorization to use it. Contact

Gateway for service.

Caution

The transmitting device embedded in this

notebook may not be used with any

antenna other than provide with the

notebook.

Caution

The 802.11A radio LAN your notebook

may have been equipped with operates

in the same frequency range as high

power radar, which has priority use, and

may damage the radio LAN if both are

present and being used in the same area.

Low power, Radio transmitter type devices (radio frequency (RF) wireless 
communication devices), operating in the 2.4 GHz band and/or 5.15 – 5.35 GHz 
band, may be present (embedded) in your notebook system. This section is only 
applicable if these devices are present. Refer to the system label to verify the 
presence of wireless devices.

Wireless devices that may be in your system are only qualified for use in Canada 
if an Industry Canada ID number is on the system label.

As a general guideline, a separation of 20 cm (8 inches) between the wireless 
device and the body, for use of a wireless device near the body (this does not 
include extremities) is typical. This device should be used more than 20 cm 
(8 inches) from the body when wireless devices are on. The power output of the 
wireless device (or devices), which may be embedded in your notebook, is well 
below the RF exposure limits as set by Industry Canada. 

Operation of this device is subject to the following two conditions: (1) This 
device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired 
operation of the device.

Unintentional emitter per ICES-003

This digital apparatus does not exceed the Class B limits for radio noise 
emissions from digital apparatus as set out in the radio interference regulations 
of Industry Canada.