Changing batteries
www.gateway.com
27
Changing batteries
Warning
Danger of explosion if battery is
incorrectly replaced.
Replace only with a battery specifically
manufactured for your Gateway
notebook. Discard used batteries
according to local hazardous material
regulations.
The battery used in this device may
present a fire or chemical burn hazard if
mishandled. Do not disassemble, heat
above 212°F (100°C), or incinerate.
Dispose of used battery promptly. Keep
away from children.
If your notebook is connected to AC power, you can change the battery while
the notebook is turned on. If your notebook is not plugged into an AC outlet,
you must turn the notebook off while changing the battery.
To replace the battery:
1
Disconnect your notebook from the optional port replicator.
2
If your notebook is on and is connected directly to AC power (not using
a port replicator), go to
-OR-
If your notebook is on and is not plugged into an AC outlet, save your work
and turn off the notebook.
3
Close the LCD panel.
4
Turn your notebook over so the bottom is facing up.
5
Slide the battery lock to the unlocked position.
6
Slide the battery release latch, then slide the battery out of the notebook.
7
Slide a recharged battery into the notebook until it snaps into place.
8
Slide the battery lock to the locked position.
Summary of Contents for NX860
