Chapter 3: Maintenance Basics
www.gateway.com
26
8
Replace the back panel by following the instructions in
.
Replacing the BIOS battery
Warning
Danger of explosion if battery is
incorrectly replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
Dispose of used batteries following the
manufacturer
’
s instructions.
If the computer clock does not keep time or the settings in the BIOS Setup utility
are not saved when you turn off your computer, replace the system BIOS battery.
Use a battery of the same size and voltage as the original battery that was in
your computer.
To replace the battery:
1
Restart your computer.
2
During the restart, press and hold the
F1
key. The main menu of the
BIOS Setup utility opens.
3
Because changing the BIOS battery will reset the BIOS to factory default
settings, write down the values you may have changed from the factory
settings, then exit from the utility.
4
Remove the back panel by following the instructions in
5
Remove the processor fan assembly by following the instructions in
“Replacing the processor fan” on page 14
6
Locate the old battery on the system board and note its orientation. You
will need to install the new battery the same way.
7
Push the battery release tab. The battery pops out of the socket.
8
Make sure that the positive (+) side of the new battery is facing up, then
press the battery into the socket until it snaps into place.
9
Replace the processor fan assembly by following the instructions in
“Replacing the processor fan” on page 14
Battery
Summary of Contents for Profile 6
