Instructions for DKC500ACL/DKC800ACL
www.gatexpertstore.com
7
Step 2 - Checking Manual Release
·
Insert the key and open the manual release bar to enable the motor get into manual mode and
check that the motor output sprocket rotates freely by hand (Figure 6).
Figure 6
Step 3 - Removing / Installing Motor Cover
·
Unscrew the two cover screws located at each side of the motor cover.
·
Remove the rubber grommet below the limit switch (Figure 7).
Figure 7
·
Sprocket cover installation as Figure 8
Figure 8
To make the motor into manual mode, insert the key
and open the manual release bar till it rotates by 90
°
.
In manual mode, the sprocket can turn
freely and the gate can be operated by
hand.
Bolts
Sprocket Cover
Turn 90
°
