background image

Federal Communications Commission (FCC) Statement     

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must accept 

any interference received, including interference that may cause undesired operation.         

 

Note: This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, uses 

and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of 

the following measures:     

     

z

 

Reorient or relocate the receiving antenna.         

z

 

Increase the separation between the equipment and receiver.     

z

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.     

z

 

Consult the dealer or an experienced radio/TV technician for help.       

 

Warning:

 Changes or modifications made to this device not expressly approved by 

GATOR 

GROUP CO., LTD

 may void the FCC authorization to operate this device.     

 

Note:

 The manufacturer is not responsible for any radio or tv interference caused by unauthorized 

modifications to this equipment. Such modifications could void the user’s authority to operate the 

equipment. 

 

RF exposure statement:

The transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.  

This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. 

This equipment should be installed and operated with a minimum distance of 20cm between the radiator

and any part of your body. 

Summary of Contents for M508












Reviews: