37
Page P.16
Important notes:
• The neutral position of the 3-axis gyro system GU-344 GYRO may deviate a little. In this case, fine adjustment must be
performed using the trimming or subtrimming at the remote control transmitter.
• It is good if the control path for the throttle/pitch function does not exceed 80% so that the 3-axis gyro system does not
leave the control range when stabilising the flight position even at maximum pitch control. Therefore, the throttle/pitch
function should be reduced from 100% to 75% after setting the speed controllers.
• Observe the remaining capacity of the flight battery. If the battery is discharged too far, it will be damaged and the
quadrocopter cannot be controlled anymore.
• High gyro stability ensures stable hover flight. Low gyro stability decreases flight stability but increases the quadrocopter’s
agility.
Lower figure:
If you want to change the flight alignment of the quadrocopter from X- to cross alignment, loosen the 3-axis gyro system
GU-344 GYRO and attach the electronics component with new adhesive pads according to the figure. The arrow on the
casing top of the gyro system must be aligned in parallel to the motor boom arm 1 then.
Then push the DIP switch 2 at the top of the 3-axis gyro system to the bottom-most position. The motors, motor rotating
directions or propellers do not need to be changed.
Important!
Before the first flight, check correct movement directions of the quadrocopter to the transmitter’s control com-
mands.
