41
3. Adjusting values
In the setting mode, you will now also hear different signals (see top line of the following table), which repeat in a
continuous loop. The point where the sequence starts again depends on the menu item called, since only those sounds are
emitted for which a value is stored as well.
After the sound signal for the desired value, slide the throttle control lever from the bottom-most position (motor off) to the
full throttle position at once.
4 sounds (high, low, high, low) are emitted as confirmation for the stored value.
The speed controller returns to the programming mode, where you can call and set the next menu item if required.
1 x brief
2 x brief
3 x brief
Braking
Off
On
Battery type
Lithium
NiMH/NiCd
Cut-off mode
turn down
switch off
Cut-off switching threshold
low
medium
high
Start mode
normal
soft
very soft
Timing
low
medium
high
4. Leaving the programming mode
If the controller is in programming mode, wait until menu item 8 is acoustically displayed. Then slide the throttle control
lever from the full throttle position to the bottom-most position (motor off) within 3 seconds of the sound signal. Depending
on cell number, 2 – 3 brief sounds are emitted, followed by a slightly longer sound. The controller is now ready for operation.
After activation of the factory settings, the controller then also leaves the programming mode.
Once the controller is in setting mode and you have stored a new value, pull the throttle control lever back to the bottom
position(motor off) right after the confirmation sound sequence. Depending on cell number, 2 – 3 brief sounds are emitted,
followed by a slightly longer sound. The controller is now ready for operation.
