檢測四個方向的定位效果，若在某一方向有繞圈現象則代表磁力計被干擾，請檢查GU-INS附近是否有導磁
定位飛行
指令向前，若機體如上圖偏左，請在HEAD旋鈕調右，這是在校正各地區磁北與GPS正北的關係。
注意：同一地區只需校正一次即可，但如果有加裝其它機構時請再校正一次，因為它有可能會影響磁場變化。
物體或有大電流通過，若有就必須隔離它或纏繞電線(如P3)。
GPS Navigation
14.If the 500X heads to the left while you move the “ELE” stick forward, please adjust the “HEAD” knob
to the right, this is the calibration of magnetic north and due north of different area.
NOTE: You only need to calibrate the magnetic north and due north once in the same area. But if you
install new devices on the 500X, you need to calibrate it again, because the new devices may influence
the magnetic field of the 500X.
15. Check the GPS positioning function from four directions, if it circles in one direction, it means the
magnetometer in GU-INS is interfered. Please check if there is any magnetic material around or
electric current goes through. if so, you need to quarantine the interference source or entwine the
power cable as illustrated in P.3.
14
MODE 1
A
B
C
D
