系統設定
為了安全起見，請先將螺旋槳取下，並注意GU-INS的燈號變化。
將機體接上電源，此時馬達會有設定響聲，MODE燈號為
紅燈閃爍。
先將遙控器的電源打開，同時把油門桿
撥到最大。
接下來把油門桿放到最低。
此時馬達會有完成設定響聲，MODE燈號轉為綠燈，
接下來將機體電源移除，完成ESC指令校正。
System Setting
1.For your safety, before setup, please remove the propellers, and note the LED lights indications
2.Turn on the transmitter, and move the
throttle stick to its top position.
3.Connect the battery to the 500X, the motors will come up
with corresponding tones, and the LED light of “MODE”
lights “ Red flashing”.
4.Then move the throttle stick to its lowest
position.
5.The motors will come up with corresponding tones, LED light
of “MODE” lights “Solid green”, and the calibration of ESCs
is completed.
on the GU-INS.
6
MODE 1
MODE 1
