GAUI Hurricane 255, Assembly Instructions Manual

P.15

尾伺服機建議使用#922095

7

A

A

B

B

IMPORTANT

請注意

2. Connect the tail pushrod to the servo. Make sure the
    servo arm is 90 degrees to the tail pushrod. 
    The ball link is recommended to install at the position 
    as shown in figure.

4. Set the Gyro “limit”properly, make sure the 
    tail pitch yoke do not touch the tail pitch
    lever mount and the tail rotor hub when the
    tail servo moves to the left and the right 
    maximum travel volumn. If the Gyro you used
    do not have the function of Limit ”, set the
    function of “ATV / End Point / Travel Adjust
    on transmitter to adjust the proper travel
    volumn of the tail servo.

3. Slide the servo mount and the tail servo along the 
    tail boom until the tail pitch lever is parallel to the 
    tail output shaft or slightly forward.

往前或往後移動尾伺服機座，使尾螺距舵柄與
尾軸平行或些微向前。(圖二)

安裝尾伺服機拉桿，需確認伺服機在中立點位置時
，舵角片需與尾管保持90

o

垂直。(圖一)

1. Install the Gyro and the tail servo.

安裝陀螺儀與尾伺服機。

5. If the tail oscillates or wags at less than 60%
    gain,you will need to move the ball link to the 
    hole which is closer to the serve Gyro limit
    properly. The ideal gain  setting is around 70%.

若停懸時陀螺儀感度在60%以下尾部就有追蹤現象
而左右搖擺，請將球頭在伺服舵角片的位置向
內移，並重新調整陀螺儀上的行程極限（Limit）
，理想的陀螺儀感度應在70%左右。  

調整陀螺儀上的行程極限（Limit）以設定適當
的尾伺服機行程，需確認伺服機在左右最大行程
位置時，尾螺距推桿座不會碰到尾螺距舵柄舵座
或尾旋翼頭而產生干涉的現象。 
若您使用的陀螺儀沒有設定行程極限（Limit）
的功能，可調整發射機上的伺服機行程功能
（ ATV / End Point / Travel Adjust）來調整
尾伺服機的左右最大行程位置。

Do not touch the tail pitch lever mount and
the tail rotor hub. 

勿接觸到尾螺距舵柄舵座或尾旋翼夾頭而產生干涉現象。

Tail servo and the heading hold gyro setup

尾伺服機與陀螺儀設定

(圖一)

5mm

(圖二)

(Fig. 1)

(Fig. 2)

The servo #922095 is recommended to be 
used for Tail.