52
Teaching in the Throttle Control Path
1.
Switch on the transmitter and verify the settings for the throttle path at the remote control. It should be 100% in either
direction.
2.
Put the throttle control lever in the full throttle position and connect the rechargeable battery to the speed controller.
3.
The motor connected to the controller emits 3 brief sounds with increasing pitch and two brief sounds after 2 seconds.
The full throttle position is saved.
4.
Then move the control lever to the bottom-most position at once. The motor now emits the 2 – 4 brief signal sounds
depending on the number of cells, then one long signal.
5.
The speed controller now has stored the actual control path of the throttle channel and is ready for operation.
Programming the Speed Controller
1. Call programming mode
• Switch on the transmitter and move the throttle control lever to the full throttle position.
• Connect the rechargeable battery to the speed controller. The motor connected to the controller emits 3 brief sounds
with increasing pitch and two brief sounds after two seconds.
• After another 5 seconds, the connected motor emits 5 brief sounds with increasing pitch.
• The controller is now in programming mode.
2. Call menu item
• In programming mode, you will now hear 8 groups of different signals that are continually repeated in a loop. After
the last sound sequence (2 x long) the 5 brief sounds with increasing tone height will be audible again before the
loop starts again. Assignment of the respective signal sounds to the menu items can be taken from the following
table.
No.
Sound sequence
Menu item or function
1
1 x brief
Braking
2
2 x brief
Battery type
3
3 x brief
Cut-off mode
4
4 x brief
Cut-off switching threshold
5
1 x long
Start mode
6
1 x long, 1 x brief
Timing
7
1 x long, 2 x brief
Call default settings
8
2 x long
Exit programming mode
• To call a specific menu item, slide the throttle control lever to the bottom-most position (motor off) within 3 seconds
of the respective sound signal.
The speed controller thus switches to setting mode for the menu item called.
