21 / 28
16540_jh_V1
Installing the propellers
Warning
Risk of injury by rotating propellers in case the motors start.
Always unplug the XT-60 connector to the LiPo battery before
working on the propellers.
Install the propellers as shown in the picture below. Pay atten-
tion to install the proper propeller to each motor. The propeller
rotation sense is written on the propeller (R/L)! The image rep-
resents the copter seen from the top.
Pos. 1 - 1348.6x3 R C-Prop yellow
Pos. 2- 1348.6x3 L C-Prop yellow
Pos. 3 - 1348.6x3 L C-Prop red
First flight
Switch the transmitter on and plug the battery to prepare the
HoTT Hornet
to fly.
Unfold the arms completely and make sure they are in the cor-
rect position.
Choose a free area for your first flight. Select first always the Atti-
tude mode because so the copter is easier to control. Take firstly
confidence with the flight attitude of the
HoTT Hornet
. Proceed
carefully and responsibly.
The included
Voltage module with SBEC
offers you the possibility
to set up to three different voltage alarms in steps of 0,1 V. Thus
read the manual of the module and of your
HoTT
transmitter.
!
First flight in Attitude mode!
1
2
3
Tri L
R+L= Servo direction
Servo 4= Yaw
1
2
3
Tri R
R+L= Servo direction
Servo 4= Yaw
