22 / 28
16540_jh_V1
Using camera / transmitter version 16540.CAM
Camera and transmitter are assembled and connected.
Scan the transmitter's frequency in your suitable optional video
goggle or video monitor.
The video signal transmission begins as soon as the battery is
connected. The channel of the transmitter is factory set to chan-
nel 01.
If you want to change the transmitting channel of the transmit-
ter, proceed as follows: Set the micro-switch bar on the trans-
mitter circuit board according to the included manual for the
desired channel.
Video transmitter technical data
No. S8460
Operating voltage DC (V): 7 - 22,2 (3S LiPo)
Width [mm]: 24
Height [mm]: 12
Length [mm]: 35
Frequency GHz: 5,8
Channels: 22
Output mW: 25
Weight [g]: 12
LED function head
Version 16540.CAM
In the head of the
HoTT Hornet
there is a LED illumination of the
eyes. The color of the LEDs can be changed through a specifi-
cally programmed control on the channel 6 of the transmitter.
Read the manual included with the Switch module SXM No.
3971.
Version 16540
In the head of the
HoTT Hornet
there is a LED illumination of the
eyes. Connect the SXM module to a free channel of the receiver.
Program a control for this channel on your transmitter. Then you
can switch the colors of the LEDs. (see SXM module manual)
