3
Please read this manual carefully before
installation and use of the gDC-100.
1.
Introduction
The gDC-100 is a substitute of the BDA 10
and is therefore compatible with the
PLEXOR
®
* inspection system for pressure
regulating stations. The gDC-100 shall be
placed in the sensing line towards a safety
provision of a pressure regulator station.
The functional pressure that occurs, shall
not exceed a value of 100 bar. Use the
matching PLEXOR
®
* connection to a
pressure regulating station.
2.
Safety measures
•
Work according to applicable
regulations and guidelines.
•
For the correct operation of the gDC-
100, the use of clean and condensate-
free natural gas (CNG) is necessary.
•
The user of the PLEXOR
®
* inspection
system must be qualified in agreement
with the nationwide regulations to
perform the functional inspections on a
pressure regulating station.
•
Before using the device, the user must
have had a PLEXOR
®
* inspection
system training.
•
A defective coupling must be replaced
with a new one. Please send the
defective coupling for analysis to
gAvilar B.V..
Installation and operation of gAvilar
Diagnostic Coupling gDC-100 PN16
Instruction sheet
67037
Rev. c
1.
gDC-100 coupling
2.
gDC-100 cap
3.
gDC-100 strap
Note
gAvilar warranty obligations do not apply in
case malfunctions due to inexpert or
inappropriate use.
Copyright © gAvilar B.V. Product information: +31 85 4897 130
GA-02.116-NL/EN/DU-01.04.20 info@gavilar.nl
This controlled document is subject to change. For latest revision visit our website at
* PLEXOR is a registered trademark of Wigersma & Sikkema B.V.
