Section 4 - General Setup and Installation Notes
The Configuration Button is your one physical interface with the Angel system. It allows you to link/pair fixtures in the
Euronet network, access the WPS feature for WiFi, do factory resets, and access the Manual Select feature.
21
Function
WiFi Mode
LED
Button
sequence
New mode
LED
Timeout
Success
Fail
Manual select
Any
-
Tap ( < 1
second )
-
Blink once
-
Next pre-set setting
-
RF Pair
Any
On
Hold 2s
RF Pairing
Flash rapid
(Fading)
30sec
Slow blink LED 5s
Rapid blink LED 5s
WiFi Pair
Access point
On
Hold 4s
WiFi pairing mode
Flash slowly
(Fading)
60sec
WiFi mode, Slow
blink LED 5s
Acces point, Rapid
blink LED 5s
Switch
between WiFi
and AP
WiFi - WPS
On
Hold 8s
Access point
-
-
Slow blink LED 5s
Rapid blink LED 5s
Access point
WiFi - WPS
Factory reset
N/A
-
Hold during
boot
Factory reset
Flash rapid
(fading)
-
Slow blink LED 5s
Rapid blink LED 5s
Button Actions
Number
Name
Discription
1
100%
All LEDs at 100% on
2
50%
All LEDs at 50% on
3
10%
All LEDs at 10% on
4
20K
The fixture has a 20K look, very blue, rich color to make your “coral pop”
5
15K
The fixture has a 15K look with a soft blue feel
6
12K
The fixture has a 12k look that is a bit warmer and contributes more to coral growth
7
10K
The fixture has a 10k look with a true warm color very nice for coral propagation
8
ALL OFF
The fixture is all off
Manual Select Levels
Manual Select is only available at the beginning of set up process. Once you’ve accessed the device via a WiFi
connection, the manual selection will no longer work. Once you’ve selected a manual level you can connect the
fixture(s) to a simple timer and it will retain that setting as power is switched on and off. This is a feature that allows
very fast set up and installation if you do not have time to configure the system any other way.