•
Do not expose the fixture to:
- condensing humidity, heavy mist, fog or direct spray;
- (ambient) temperatures outside the specified range;
- dust and contamination;
- direct sunlight during use or HID light that could heat up the ballast.
•
Always cut the power to the fixtures before performing any maintenance.
•
Always allow for a cool down period of at least 30 minutes before touching the lamp or the housing. Touching the lamp or
the housing when the lamp is lit or immediately afterwards will result in severe burns!
•
Never touch the lamp with bare hands as this will cause damage to the lamp.
•
Do not use the fixture near flammable, explosive or reactive substances. The lamp reaches temperatures of >250 °Celsius /
482 °Fahrenheit.
•
Do not use sulfur vaporizers or water misters. Sulfur and calcium deposits on your lamp will decrease its efficiency.
•
The installation and use of the fixture is the responsibility of the end user. Incorrect use or installation can lead to failure
and damage to the fixture. Damage to the fixture and electronic circuitry as a result of incorrect installation and use revokes
the warranty.
5
Installation
Warning!
Mounting and installing of the fixture may only be executed by certified service personnel, in accordance with the
applicable local laws and regulations.
Warning!
The fitter is responsible for correct and safe installation.
Warning!
Ensure the local cabling can support the voltage and current requirements of the fixture.
Warning!
Avoid coiled cords and keep mains leads separated. This prevents electromagnetic interference.
Warning!
Do not connect or disconnect the fixture under load.
5.1
Installation preparations
•
Switch off mains power.
•
Read the Gavita light distribution plan.
•
If not done already, install the lamp in the fixture (1).
5.2
Installing the fixture
•
Position the hooks around the suspension profile (2).
•
Twist the fixture 90 degrees and suspend the fixture (3).
•
Connect the power cable to a power source (4).
Cable description:
Wire
400V
Brown
Phase (L)
Blue
Phase (L)
Green/yellow
Ground ( )
Caution!
Always make sure the suspension profile is aligned horizontally.
2.
3.
L
4.
250W
0,25 m -
10 in
5.
1.
