Safety notes
l
Caution – modifying or adjusting equipment can lead to dangerous radiation exposure.
l
While the product is in operation, be careful not to expose your eyes to the emitting laser
beam. An exposure to the beam of a Class 2 laser is considered safe for a maximum of
0.25 seconds. Eyelid reflexes will normally provide adequate protection.
l
Do not stare directly into the beam or view directly with optical instruments or set up
the laser at eye level.
l
Have the measuring tool repaired on through qualified specialists using original spare
parts. This ensures that the safety of the measuring tool is maintained.
l
Do not allow children to use the laser measuring tool without supervision. They could
unintentionally blind other person or themselves.
l
Do not operate the measuring tool in explosive environment, such as in presence of
flammable liquids, gases or dusts. Sparks can be created in the measuring tool which
may ignite the dust or fumes.
l
Do not make any modifications to the laser equipment.
Intended use
The measuring tool is intended for determining and checking horizontal and vertical lines.
The measuring tool is suitable exclusively for operation in enclosed working sites.
Replacing the batteries
To open the lion battery pack
, press on the latch. See picture
②
for detailed information.
To
replace the lion battery pack,
sound click means assembly completed.
(Note: Remove the batteries from the measuring tool when not using it for extended periods.
Recharge the battery pack before use when stored for more than 6 months.)
Working safely with the measuring tool is possible when the operating and safety
information are read completely and the instructions contained therein are strictly
followed. Save these instructions for reference.
