2.
Manual Mode
In manual mode the measuring tool won’t be self-levelling. It could be held by hand or placed
on an inclined surface to project a rigid laser beam in any orientation.
To switch on and off the measuring tool, press and hold the mode key for more than 3
seconds.
l
Immediately after switching on, the measuring tool sends out horizontal beam.
l
To change the laser beam, shortly press the mode key repeatedly to cycle through the
available modes. The following sequences are available.
Lock Switch Position
Short Press
Sequences
Horizontal
Laser Line
Front Vertical
Laser Line
Side Vertical
Laser Line
Lock
1(>3s)
■
Lock
2
■
Lock
3
■
■
Lock
4
■
■
Lock
5
■
■
■
Lock
6
Turn off
l
The laser lines flash every 5 seconds to save energy.
