Occasionally our products contain components that are
pre-lubricated at the factory. We recommend that you
protect fl ooring, or anything else the parts may contact,
with newspaper or cloth.
Tools Required for Assembly:
Phillips Screwdriver
Wrenches (provided)
spare
washers
wrenches
spare handle bolts
& spring washers
axle tube bolts
& spring washers
& flat washers
axle tube assembly
hand grip
assemblies
right
frame
assembly
left
frame
assembly
right
swing arm
assembly
left
swing arm
assembly
cables
b
front
frame
rear frame
(curved)
fastener pack
ASSEMBLY INSTRUCTIONS
a.
Lay the two frame assemblies & swing arm assemblies
on the floor as shown. Make sure the rear frame is on top
& that the cables pass freely above all the frame tubes.
Note: Be careful you do not allow the cable to get behind
the swing arms.
b. Remove all the bolts at the bottom of the frame assembly.
There are two on the rear frame & two on the underside
on the front frame.