Connection scheme
Default jumpers J1 and J2 are mounted on the relay board
unit.
Jumper J1 is supposed to turn the video camera on for 10
seconds each time the car engine starts (АСС mode is
engaged). This allows assessing the situation behind the car
not only when you shift to reverse but immediately before
starting the car.
Jumper J2 is supposed to turn the deactivation delay timer.
Thanks to this function, the video stream from the camera
will be displayed on the monitor for 10 seconds after the
reverse gear is disengaged. This will ensure that the driver is
always aware of the situation behind the car during frequent
shifting of gears and in case of complicated parking
«in several moves».
Scheme a relay unit AC105
Connection scheme
By default, Gazer СС125/CC155 video cameras transmit a
mirrored video signal in PAL format with a parking assist
overlay. To change the mode of operation, one needs to cut a
corresponding wire.
Scheme connector cameras CC125/CC155
1. - white
(parking assist overlay)
2. - green
(PAL or NTSC)
3. - black
(video signal mirroring)
Warning!
Make sure that you insulate the wires after
cutting. Failure to comply with this recommendation may
result in video camera malfunction.
Note:
We recommend changing the video camera
operation modes when the device is turned off. The video
camera must be reset after wire 2 (PAL or NTSC) has
been cut.
10
ENG
Summary of Contents for CC Series
Page 1: ...USER MANUAL OF BACKUP CAMERAS GAZER CC series ...
Page 2: ......
Page 39: ......
Page 40: ......
