10
Release the multimedia system control unit by unscrewing 2 screws as shown in
figure 3
.
Figure 3
Detach the multimedia system control unit from the shaft after switching off power and the CAN bus.
Unscrew 4 fastening screws as shown in
figure 4
.
Detach the multimedia system display after switching off power and the CAN bus.
Figure 4
To install the interface, it is necessary to reconnect the LVDS cable of the display of the multimedia
system using the adapter from the installation kit.
Install the LVDS adapter, this requires dismantling the connector "
1
" in
figure 5
by connecting it
using the adapter (
Fig. 6
). Connect LVDS out of video interface "
2
" to LVDS in of the monitor "
3
" and
LVDS out of the monitor "
4
" to video interface’s LVDS in "
5
".
To connect power and CAN bus use the adapter from the kit by connecting it to the plug "
6
", (
Fig.
5
).
