GAZONEO PRP200DE, User And Maintenance Manual

Most  popular  chemicals,  you  may  be  accustomed  to  use  in  wet  powder  form,  are  also  available  in  liquid 
form. 

 
WARNING! 

Never spray insecticides with a sprayer that has been used to spray herbicides, unless the unit has been 

completely cleaned and flushed using the correct neutralizer as per the herbicide manufacturer’s i

nstructions.   

Failure to do so can result in the killing of plants. 

 
4.4- Putting the sprayer on your back 

With your sprayer ready for use, it is recommended to place the sprayer on a table or other higher level 
surface.   
Once on a table or high level surface, you may pass both arms through the shoulder straps, and then pull 
firmly down on the loose ends to tighten the straps.   
By using this method, you will avoid unnecessary twisting or turning, and be able to tighten the shoulder 
straps more easily. 

 
V.    OPERATION 

 
5.1- Intended use 

This product is intended for the pulverization of chemicals on plants. 
It should only be used for the dispersion of phyto products, pesticides, herbicides and liquid fertilizers, 
authorized and available in the specialized shops.   
Always observe the instructions of the manufacturer of the liquid product. 
Do not disperse other products with this sprayer. 
Any other use different from that stated in this manual can cause damage to the product and present a serious 
danger to the user 
Do not use the sprayer for any other use, such as spraying varnish! 
 

REMINDER 

Keep people and animals away from the work area. 
Never spray towards people, animals or objects that can be damaged.   
Remember that the high-speed output nozzle spray can throw objects violently which could become a source 
of danger. The user is solely responsible for the dangers and damage occurring to third persons or property. 
 

5.2- Starting and stopping the sprayer 

(Fig.5) 

ATTENTION: before first use, ensure to fit the fuse on the fuse holder (b). 

 
(a) Charging inlet 
(b) fuse holder 
(c) Switch 3 positions : 
 

0 : OFF 

I : ON (pressure 3 bars) 

II : ON (allows to adjust the pressure from 0 to 3 bars)   

(d) Pressure controller (knob allowing to adjust the working pressure when the 
switch is in position II) 

Fig.5