54
make sure the vehicle is on level ground. check
the recline angle. adjust the seat angle until the
red line on the infant carrier is level with the
ground. a tightly rolled towel or pool noodle
may be placed under the infant carrier near the
vehicle seat back to adjust the angle.
see page 65.
the gB idan is allowed to touch the vehicle
seat(s) in front of it, as long the recline angle of
the gB idan is not affected.
always have the handle locked in position a while
using this child restraint in a vehicle.
grab the infant carrier at the Belt guides and pull
from side to side and front to back to make sure it
is installed correctly. the infant carrier should not
move more than 1 inch (2.5 cm) in any direction.
if the infant carrier moves too much, tighten the
vehicle belts more and recheck. you may try a
different vehicle seat or installation method, or
both.
if the infant carrier is next to a vehicle door or
panel, extend the adjacent l.s.p. (linear side
impact protection) device. see page 63.
InStallInG Infant CarrIer only wIth a lap/ShoUlder belt
6
7
6
7
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
Summary of Contents for IDAN
Page 1: ...en I D A N F u t u r e p e r f e c t...
Page 73: ...EN 73 NOTES...
Page 75: ...Es es I D A N F u t u r e p e r f e c t...
Page 147: ...73 Es NOTAS...
