GBA Global Bill Acceptors
GBA GV1 Operation Manual
Astrosys International Ltd
October 2018
GBA GV1 Operation Manual v2.00 Page 29 of 33
Mode
Status/Description
l
a
s
h
i
n
S
t
e
a
d
Pattern - Four fast-flashes
ST2 is not the one locked to
this ST2
Red
Orange
Orange
Red
Supply Voltage Low
(<10.5Volts)
Red
Orange
Orange
Orange
Real Time Clock Battery
Fault (no charge left)
Red
Orange
Red
Red
Bill stacker is jammed
Red
Orange
Red
Orange
Printing Dispute Resolution
Report
Green
Green
Green
Orange
Printing Audit Report
Green
Green
Green
Red
Checking a new Smart
Cassette
Green
Orange
Green
Orange
*
OASG = Optical Anti-Stringing Gate
**
MASG = Mechanical Anti-Stringing Gate
***
This condition only occurs in serial interfaces, e.g. GBA RS-232, MDB, ccTalk®
Note: The 'GV1' LED Indicator is also utilised when the GV1 unit is flash-programmed from a USB
memory device. The process & error codes generated during this type of operation are shown in
section 6.3.6.
10.1.3 'VAL' Diagnostic LED
Refer to this table for codes displayed by the 'VAL' Diagnostic LED indicator, reflecting the specific
operational status of the ST2 validation module.
Mode
Status/Description
Flashing
Steady
Flash 1 Flash 2
Standby
Modes
Unit OK/Idle
Green
Unit Disabled/Inhibited
Orange
Unit out of order - Hard Fault
Red
Active
Modes
Unit Busy
Green
Auto Calibration
Orange
Orange
