© 2006 General Binding Corporation
Page 9
FEATURES GUIDE
This chapter helps you identify the main components of the laminator.
Fig. 5-1. Laminator Identi cation. (Artic Titan 1064 WF c Shown Without Print Clamp.)
TOP FILM SUPPLY SHAFT
Holds the film supply on the laminator.
RELEASE LINER TAKE-UP
Rewinds the release liner of pressure sensitive films. It
consists of a shaft, core adapters, and cardboard core.
IDLER BAR
The idler bar directs the film to the roller.
PRESSURE ROLLERS
Two pressure rollers apply pressure to the film and the print
being laminated or mounted. They pull the print and films
into the laminator
.
NIP POINT
(Not shown.) The point at which the top and bottom rollers
come into contact and the point at which the items for
lamination are introduced into the laminator.
FEED TABLE
The feed table is used to position items for laminating and
mounting.
When the feed table is removed, the laminator
runs at 3 fpm (0.9 m) when you press the foot switch.
The
feed table is removed only when you load film.
Pressure roller
Safety sensor
Feed table
Feed table interlock
latch (under table)
Bottom supply shaft
Food switch
Roller pressure
handle
Control panel
Top film shaft (Not Shown)
Release liner take-up
Bottom supply shaft
Idler
Idler
