GBC 620os
Operation Manual
© 2007 General Binding Corporation
Page 15
LOADING FILM & THREADING FILM
Figure5
Figure 6
Figure 7
STEP 5:
•
Attach the end of the Threading Card to the
activated film. The
Top Main Roller
must be
hot to activate the adhesive to ensure that the
Threading Card sticks. (
Figure 5
).
•
Replace the
Safety Shield
and lock in the
Safety
Shield’s Safety Interlocks.
STEP 6:
•
While pressing “
LOADING
”, push another sheet
into the nip area under the sheet you just tacked
to the film. (
Figure 6
).
•
Continue holding down “
LOADING
” until the
first sheet enters the
Burst Rollers
while feeding
additional sheets.
•
Once the first sheet exits the
Burst Roller
s,
release “
LOADING
”.
STEP 7:
•
Verify that the “Threading Card” and images are
traveling over the
Decurling Bar
. (
Figure 7
).
Monitor the amount of curl of the finished
laminated images. Adjust the Decurling Bar
Knob to increase or decrease the amount of curl
desired.
•
Press “
START
”
•
When the green LED is illuminated, place
another image onto the
Feed Belts
and guide it
into the
Feed Gate
. The
Feed Gate
will
automatically activate according to sheet size and
open, allowing the image to be entered into the
nip.
•
When the green LED is illuminated, place
another image onto the
Feed Belts
and guide it
into the
Feed Gate
.
STEP 8:
•
Set the
In-Line Perforator Wheel
on the very
outer edge of the image but still making contact
with the film. Make any adjustments needed to
ensure the
Perforator Wheel
is penetrating the
film, leaving small holes in the film. Verify that
the gray wheel is off the image. (
Figure 8&8A
).
Figure 8A
