GBC 620os
Operation Manual
© 2007 General Binding Corporation
Page 16
LOADING FILM & THREADING FILM
Figure 9
Figure 10
Figure 11
Figure 12
STEP 9:
•
Place the
Prelaminating Film Perforator Wheel
on the edge of the Supply Roll of film. Verify
that the
Prelaminating Film Perforator Wheel
is penetrating the film, leaving small holes in the
film. Not necessary for all films. (
Figure 9
).
STEP 10:
•
Set the
Skew Wheel
as shown in figure 10. The
angle and position of the
Skew Wheel
will
determine how much of a “tent” is present. For
proper “snapping” or “separation” of the images,
a small “tent” is needed as shown in figure 10.
STEP 11:
•
At this point, the Bursting Location can be
determined by referencing the decal shown in
Figure 12.
•
Watch the images as they pass through the
Pull
Rollers
and into the
Burst Rollers
. When
determining the location of the “Burst”, the
overlap should be past the
In-Line Perforator
Wheel
but before the
Skew Wheel.
•
Match up that location with the Decal in Figure
12. Observe the number value that represents the
location you want start snapping. Ex. 620.
•
Press “
BURST
”, (
Figure 11
) and then use the
Master Dial
to dial in the desired value. Ex 610.
The numeric value on the
Main LCD
will change
as you rotate the
Master Dial.
•
At this point, activate the Burst Rollers by
pressing
BURST ON/OFF.
•
Ensure that the sheets are being separated by the
Burst Rollers
. If more speed is needed for
bursting, press
BURST SPEED
. This will
increase the
Burst Rollers
, which gives you
better sheet separation.
