GBC 620OS, Installation And Operating Manual

GBC 620os 

Operation Manual 

© 2007 General Binding Corporation  

Page 8 

FRONT CONTROL GUIDE 

Figure 2 

LCD Display: 

•

HEAT: 

This displays the Temperature the 

machine is set at. 

Figure 2

. indicates the set 

e 

e location 

run 

 the 

nt will indicate how 

many sheets of media were run through the 
laminator.  To reset the counter to “0”, press 

RESET

 shown in 

Figure 1.

temperature is 32*F.  To read the actual 
temperature of the 

Heat Roller

, press and hold 

the 

MASTER DIAL

. (

See Figure 1

.)

•

WAIT: 

After setting the desired temperature, the 

LCD

 will display “

WAIT

” until the temperatur

reaches the set point.  After the machine reaches 
the set point, the 

LCD

 will read “

READY

” and 

the operator can start running the machine.

•

BURST: 

The Burst value tells the laminator 

when and where to activate the 

Burst Roller

.  A 

decal located on the side frame between the pull 
rollers and the 

Bursting Roller

 reflects values 

from a range of 580-660.  To change th
of the burst, press the 

BURST

 then turn the 

MASTER DIAL

 to dial in the desired value in 

relation to the decal on the side frame

. 

•

SPD: 

The Abbreviation “

SPD

” refers to the set 

speed of the machine.  The range of speed is 1-
15. At speed 01, the machine will 
approximately 3ft/mn.  Each increment is equal 
to about 3ft/mn. 

SPD

 15 is 45ft/mn.  To adjust 

this value, use 

MOTOR SPEED

. 

Figure 1

.

•

LENGTH: 

The value displayed next to length 

refers to the sheet size of the media being used.  
In 

Figure 2

. the medias sheet length is 18 inches. 

To adjust the length, press 

LENGTH

 and use

MASTER DIAL

 to increase or decrease your 

sheet size. The sheet size ranges from 8 inches-
30inches and increases by 1/32

nd

 increments.

•

SHEET COUNT: 

Sheet cou

Figure 3 

•

HEAT: 

(

Figure 3

.) After setting the 

Heat Roller

temperature, the laminator is protected with heat 
sensor protection.  In the event that the 

IR 

Sensor

 fails, or a foreign object such as a misfeed 

image blocks the 

IR Sensor

, the

 IR Sensor

 will 

detect a sudden/drastic change in temperature and 
an alarm will sound and “H-Err”

will appear on 

the 

LCD

.  Stop the laminator by pressing 

STOP

, 

locate the 

IR Sensor

, (

Refer to Know Your 

Laminator Section

) and clear the image from the 

path of the 

IR Sensor.

 Rest the alarm by pressing 

the

 MASTER DIAL

. (

Figure 1.

) At this time, 

simply press 

RUN

 and continue the job.