11
Operating Instructions
62FM L
AMINATOR
T
IPS
FOR
M
OUNTING
ON
P
RE
-
COATED
B
OARDS
Fig. 6-21. Mounting a Print on a Board.
Load the laminator as illustrated as shown.
Heat at 125 °F (52 °C), may assist the process
and increase output quality.
Do not stop once you have started the
mounting process through the machine.
T
IPS
FOR
PSA E
NCAPSULATION
Fig. 6-22. PSA Encapsulation With Poly-in Film.
Load the laminator as shown.
Always use two rolls of the same width.
Use minimal brake tension to achieve flat
output.
•
•
•
•
•
•
The separation of the laminate and the release
liner should be maintained close to the heat
rollers.
A little heat, 125 °F (52 °C), may help eliminate
silvering effects associated with PSA films.
Use of the chill idler may or may not help in
the output quality. Try both methods.
T
IPS
FOR
T
HERMAL
E
NCAPSULATION
Fig. 6-23. Thermal Encapsulation With Poly-in Film.
Load the laminator as shown for poly-in film.
Always use two rolls of film the same width.
Use minimal brake tension to achieve flat
output.
Increase speed gradually to maintain the
activating temperature required for the
laminate you are using.
Length and width of image, ink coverage and
paper type may effect the temperature and
speed required.
•
•
•
•
•
•
•
•
Board
Liner
Summary of Contents for 62FM
