Page 4 - 18
Installation
Digital Feeder Operation and Maintenance Manual
© GBC Pro - Tech February 2000
c) Push the opposite end of the pneumatic tube
into the air fitting of the cutter located below the
main power ON/OFF.
When finished with all of the
necessary connections, zip ties should be
used to neatly route the cables, pneumatic
hoses and cords. This will prevent
entanglement with these items while
working around the system.
INFORMATION
D o n o t p i n c h t h e p n e u m a t i c t u b i n g w h e n
using zip ties to route. Pinching will
constrict the air flow.
4.9 Safety check
The safety check will ensure that all safety devices
and interlock switches are functioning properly. Refer to
Section 5 Operations for detailed explanation of the
control panel.
W A R N I N G
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the feeder. These items can
get caught in the machine and choke
you or you can be crushed.
W A R N I N G
If a safety feature is not functioning
properly, contact your local service
representative immediately
Safety on the feeder consists of the sheet table
upper limit switch, sheet table lower limit switch and an
emergency stops ( E-STOP ). Do not have the laminator
webbed.
INFORMATION
The Explorer 107 and the Digital Feeder
must both have power turned to ON.
