Page 8 - 4
Maintenance
F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
When cleaning the bottom main roller,
switch the motion direction to reverse.
When cleaning the bottom pull roller,
switch the motion direction to forward.
This will prevent anything from
being pulled into the nip.
INFORMATION
W A R N I N G
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
d) Since the safety shields are raised and the
tables removed, you must use the footswitch to
rotate the bottom rollers after cleaning a
section.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
Cleaning the beads of
adhesives, dust and dirt from
the rolls
This can be done one of two different methods.
Both are acceptable forms of cleaning the beads of
adhesives, dust, and dirt from the rolls.
Method 1
a) Allow the laminator to cool slightly to no
higher than 110
o
F ( 43
o
C ).
TOP TEMP
BOT TEMP
-
-
<110
<110
b) Set the motion direction to REV
▼
.
S P E E D
SAFETY
F W D
R E V
00.0
G O
S T O P
