F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 6 - 57
Applications
W A R N I N G
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
e) Push the leader board into the main roller nip
while stepping on the variable speed footswitch.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
f) Apply the minimum amount of brake tension on
the roll of Hot Tissue to prevent it from free
spinning.
Excessive tension will cause the
substrate to bow.
INFORMATION
g) Have the second person stand at the rear of the
laminator.
INFORMATION
Steps " h " and " i" will be performed
simultaneously.
W A R N I N G
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
h) With the stack of substrates within reach of the
first person, step on the variable speed
footswitch while sliding one board in after the
leader board with a 1/2 inch gap between the
two. Refer to Figure 6.6.4
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
The 1/2 in. gap between boards will allow
for easier separation of the boards by
the second person.
INFORMATION
